B – 02 Standard Specification for Aluminum and Aluminum-Alloy Drawn Seamless Tubes, aluminum alloy, aluminum-alloy drawn seamless tubes. ASTM B Standard Specification for Aluminum and Aluminum-Alloy Drawn Seamless Tubes. Drawn Aluminum Tubing from TW Metals is a magnesium and silicon alloyed aluminum product with good corrosion resistance and formability. Call now!.
|Published (Last):||25 February 2004|
|PDF File Size:||13.93 Mb|
|ePub File Size:||17.93 Mb|
|Price:||Free* [*Free Regsitration Required]|
The tension tests shall be made in accordance with test methods B M. B Analysis shall be made for the elements for which limits are shown in this table.
F Other elements Total shall be the sum of unspecified metallic elements 0. T4, T42 H 0. The producer may analyze samples for trace elements not specified b2110 the specification. Tensile Strength, ksi Yield Strength D 0. I Alloy clad with Alloy This specification covers aluminum and aluminum-alloy drawn seamless tubes in straight lengths and coils for general purpose. The samples from finished tube shall not be required to conform to these limits.
Should any analysis by the producer or the purchaser establish that an G210 element exceeds the limit of Each or that the aggregate of several Others elements exceeds asttm limit of Totalthe material shall be considered non-conforming. E Others includes listed elements for which no specific limit is shown as well as unlisted metallic elements. The tube shall be produced by drawing an extruded tube made from hollow extrusion ingot cast in hollow form or pierced and extruded by the use of the die and mandrel method.
When specified, heat treatment of applicable tempers shall be in accordance with practice B Note 2—Throughout this specification, use of the term alloy in the general sense includes aluminum as well as aluminum alloy. A Limits are in weight percent maximum unless shown as a range or otherwise stated. b20
Alloy Alclad F. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard. The different methods for leak testing of tubes are presented.
ASTM does not give any warranty express or ast, or make any representation that the contents of this abstract are accurate, complete or up to date.
The determination of chemical composition shall be made in accordance with suitable chemical test methods E 34or spectrochemical test methods E and Emethods.
Alloy F O 0. This abstract is a brief summary of the referenced standard.
However, aztm analysis is not required and may not cover all metallic Others elements. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. The equivalent Unified Numbering System alloy designations are those of Table 1 preceded by A9, for example, A for aluminum designation in accordance with Practice E The tubes shall conform to the chemical composition requirements specified.
Flattening test specimens shall be flattened sidewise under a gradually applied load so as to give a uniform radius of bend until the minimum outside diameter under load is not more than F times the wall thickness of the tube as specified. C For purposes of determining conformance to these limits, an observed value or a calculated value obtained from analysis shall be rounded to the nearest unit in adtm last right-hand place of figures used in expressing the specified limit, in accordance with the rounding-off method of Practice E Aluminum F O 0.
Historical Version s – view previous versions of standard. J Composition of cladding alloy as applied during the course of manufacture. H Bb210 aluminum content shall be calculated by subtracting from Link to Active This link astn always route to the current Active version of the standard.
It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. The tube shall conform to the tensile property requirements specified.
Work Item s – proposed revisions of this standard. Alloy Alclad F O 0. Coiled tubes are generally available only as round tubes with a wall thickness not exceeding 0.